CHAMPION DH5000 VHR Manual - Manual (Page 26)

18
1. Turn the main power on at the main circuit breaker.
2. Make sure the spray arms and the scrap screens are in place.
3. Turn the water supply on.
4. Close the dishwasher hood.
5. Push the Cycle Selector Switch UP to the STANDARD position.
6. Push the dishwasher Power Switch to the ON position. The power switch will illuminate
and the machine will fill with water.
7. Check the pressure gauge as the machine fills and make sure the incoming water flowing
pressure is between 20-22 psi.
POWER WASH
ON
CYCLE
PRESSURE
STANDARD
OFF/DRAIN EXTENDED
WASH
150°F
RINSE
180°F
1 5 0 1 7 0
Operation
Follow the instructions below to operate the dishwasher in a Standard Wash Cycle. A Rinse
Sentry feature holds the dishwasher in a wash cycle if the booster heater temperature is below
180ºF/82ºC.
Standard Wash Cycle Operation
POWER WASH
ON
PRESSURE
STANDARD
EXTENDED
RINSE
180°F
10
0
30
20
PSI
60
50
40