CHAMPION DH5000 VHR Manual - Manual (Page 12)

4
Refer to the illustration below and on the next page to convert a straight-through operation
machine to a corner operation machine.
To convert the dishwasher:
1. Place the dishwasher as shown below so the control panel faces into the room
and is accessible to the operator.
2. Refer to the illustrations on the next page and cut a notch in the dish table backsplash
if it is higher than 3" [76 mm].
3. The dishwasher should be positioned in a manner whcih allows the dish tables and the
machine to align for the proper loading and unloading of the dish racks.
4. Make the utility connections as described in this manual and in accordance with all
local codes and regulations.
5. Install the dish tables so the edge of each table fits over the inner wall of the dishwasher
tank.
6. Secure the dish tables to the dishwasher
7. Seal each dish table joint with a food-grade sealant to prevent leaks.
Installation
Converting Straight-through Operation to Corner Operation
Control
Panel
Corner Operation Shown
! ATTENTION !
A straight-through machine can be converted to a corner configuration in the field
BUT
the clean-end dish table will have to be modified if its backsplash is over 3" [76mm] high.