Carlin 301CRD - Manual (Page 15)

Model 201CRD & 301CRD 240-VAC Advanced oil burners — Instruction manual
Carlin part number MN2301A Rev. 10/21/10
– 15 –
3. Prepare burner
(continued)
Perform checkout procedures
Verify before starting burner:
Should overheating or an emergency occur, immediately:
• Shut off oil supply line valve.
• Under some circumstances power should remain on for
water pumps or blowers. Determine proper response before
attempting start-up.
• If burner fails ignition on several attempts, use burner
blower to purge appliance chamber before restart.
Checklist
Burner/appliance installed per appliance instruction manual?
Burner nozzle verifi ed per appliance manufacturer’s instructions,
Carlin OEM Spec Guide or Table 1, page 3?
Burner/appliance installed per all applicable codes?
Installation site has adequate combustion/ventilation air openings
and vent system?
Fuel supply line in good condition and sized/designed correctly?
Oil tank has oil and oil line valves are open.
Wiring installed per burner manual and appliance instructions?
Burner, appliance and all components inspected and in good
condition?
Oil fl ow schematics / fuel unit connections
• Figures 16, 17 and 18 show oil fl ow for Carlin 201 and 301 burners and
show port functions for Suntec Model A, B, J and H pumps.
• Figure 18 applies only for optional NYC-DAR pressure regulation kits.
Figure 16 201/301 burner with Suntec Model J or H fuel unit
Figure 17 201/301 burner with Suntec Model A or B fuel unit
Figure 18 201/301 burner with NYC-DAR pressure regulation kit
Obtain pressure regulator kits for New York City Department
of Air Resources. Kits must be set for the proper nozzle pres-
sure.