BAND-IT T30069 Center Punch Hand Tool - Manual (Page 3)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P15087 rev. H
© Copyright
BAND-IT-IDEX, Inc. 2011
All rights reserved
www.BAND-IT-IDEX.com
Page 3 of 5
T30069
CP Hand Tool
INSTRUCTIONS:
DISSASSEMBLY AND ASSEMBLY OF PUNCH
To replace the punch (10), remove the head spring pin (3). Rotate the punch holder (11) until the
retaining ball (12) is visible on the inside of the head (19). Remove the retaining ball and pull the punch
out. Replace the punch and reassemble in reversed manner.
(6X)
Retaining Ring
22
1
2
3
4
INCLUDED ACCESSORY
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
21
20
7
Tool Assembly
15