B&W Trailer Hitches 1316R - Manual

B&W Trailer Hitches
1216 Hawaii Road / PO Box 186
Humboldt, KS 66748
800.248.6564
620.473.3664
Fax: 620.473.3766
Turnoverball TM Gooseneck Hitch Installation Instructions
Call or Email us for Installation Support
Model 1316R
Dodge 2002-2008
1/2 Ton, Long & Short Bed
Two and Four-Wheel Drive
[email protected]
www.turnoverball.com
BEFORE INSTALLING
OVERHEAD LIFTING DEVICE
An overhead-lifting device, such as chain falls, engine hoist, or cable come-a-long, can be used to lift the center sec-
tion of the hitch in place. Lower a loop of rope or chain through the 4” hole in the truck bed floor and attach it to the
latch pin in the round hitch receiver tube in the center section. Use the lifting device to raise the center section until
the round hitch receiver tube that protrudes from the center section fits in the 4” hole in the truck bed floor. Main-
taining upward pressure may facilitate fastening the crossmember to the center section, especially if the truck bed
floor has been distorted downward from heavy use. If you use an overhead-lifting device, it should be disconnected
before squaring the center section across the frame, installing the sideplates and torquing fasteners.
NOTE: We recommend reading instructions before beginning the installation.
WARNING: The tow vehicle’s towing capacities should under NO circumstances be exceeded.
Center Box (GNRC900)
ITEM DESCRIPTION QTY
8 Center Section 1
9 2-5/16" Ball 1
10 Latch pin Handle 1
Safety Chain Kit Bolt Bag
11 1/2” U-Bolt 2
12 Conical Springs 4
13 1/2” Lock Nut 4
5/16” X 3/4” Carriage Bolt 1
5/16” X 3/4” Cap Screw 1
5/16” Lock Nut 1
Mounting Kit Box (GNRM1316)
ITEM DESCRIPTION QTY
1 Driver Side Plate 1
2 Passenger Side plate 1
3 Front Crossmember 1
4 Rear Crossmember 1
5 Clamping Strap 4
6 Spacer 1
Mounting Kit Bolt Bag
7 1/2” J-Bolt 2
1/2" X 1-1/2" Cap Screw 11
1/2” X 4-1/2” Cap Screw 8
1/2" Flat Washer 13
1/2" Lock Washer 21
1/2" Finish Nut 15
NOTICE: This product was designed to fit vehicles in their original,
“as manufactured” condition. Compatibility with vehicles having
replacement parts, or other modifications is not guaranteed. Inspect
vehicle for modifications before installation of this product.