B&W Trailer Hitches 1111 - Manual

Model 1111
www.turnoverball.com
Call or Email us for Installation Support
800.248.6564 [email protected]
Turnoverball TM Gooseneck Hitch Installation Instructions
B&W Trailer Hitches
1216 Hawaii Road / PO Box 186
Humboldt, KS 66748
P:620.473.3664
F:620.473.3766
Ford Super Duty 2011-2015
3/4 & 1 Ton, Short & Long Bed
F-450 w/Factory Installed Bed
An overhead-lifting device, such as chain falls, engine hoist, or cable come-a-long, can be used
to lift the center section of the hitch in place. Lower a loop of rope or chain through the 4” hole
in the truck bed floor and attach it to the latch pin in the round hitch receiver tube in the center
section. Use the lifting device to raise the center section until the round hitch receiver tube that
protrudes from the center section fits in the 4” hole in the truck bed floor. Maintaining upward
pressure may facilitate fastening the crossmember to the center section, especially if the truck
bed floor has been distorted downward from heavy use. If you use an overhead-lifting device,
it should be disconnected before squaring the center section across the frame, installing the
sideplates and torquing fasteners.
BEFORE INSTALLING-
OVERHEAD LIFTING DEVICE
Attention:
If you intend to use an 18K Companion 5th
Wheel RV Hitch model 3000 in a 2011 Ford
Truck, please call us at 800-248-6564 for a
foot pad kit that fills voids in the truck bed
rib pattern. Using the Companion on a 2011
Ford without the supplemental kit could re-
sult in damage to the bed.
NOTE: We recommend reading instructions before beginning the installation.
WARNING: The tow vehicle’s towing capacities should under NO circumstances be exceeded.
Mounting Kit Box (GNRM1111)
ITEM DESCRIPTION QTY
1 Driver Side Sideplate 1
2 Passenger Side Sideplate 1
3 Front Crossmember 1
4 Rear Crossmember 1
5 Exhaust Bracket 1
6 Sensor Relocation Bracket 1
Mounting Kit Bolt Bag
7 Exhaust Bracket Spacer 1
8 Mounting Spacer 2
9 3/4” Custom Rectangle
Washer
1
1/4” X 3/4” Carriage Bolt 1
1/4” Flange Nut 1
5/16” Carriage Bolt 3
5/16” Flange Nut 3
1/2” X 1-1/2” Cap Screw 14
1/2” Flat Washer 14
1/2” Lock Washer 14
1/2” Finish Nut 14
3/4” X 2-1/2” Cap Screw 2
3/4” Flat Washer 1
3/4” Lock Washer 2
3/4” Finish Nut 2
Center Box (GNRC800)
ITEM DESCRIPTION QTY
10 Center Section 1
11 2-5/16” Ball 1
12 Latch Pin Handle 1
Safety Chain Kit Bolt Bag
13 1/2” U-Bolt 2
14 Conical Springs 4
15 1/2” Lock Nut 5
5/16” X 3/4” Carriage Bolt 1
5/16” X 3/4” Cap Screw 1
3/8” Lock Nut 1
NOTICE: This product was designed to fit vehicles in their original, “as
manufactured” condition. Compatibility with vehicles having replacement parts,
or other modifications is not guaranteed. Inspect vehicle for modifications
before installation of this product.