B&W Trailer Hitches 1100R User Manual
Before installing, Turnoverball, Gooseneck hitch installation instructions
An overhead-lifting device, such as chain falls engine hoist, or cable come-a-long, can be used to lift the center
section of the hitch in place. Lower a loop of rope or chain through the 4” hole in the truck bed floor and
attach it to the latch pin in the round hitch receiver tube in the center section. Use the lifting device to raise
the center section until the round hitch receiver tube that protrudes from the center section fits in the 4” hole
in the truck bed floor. Maintaining upward pressure may facilitate fastening the crossmember to the center
section, especially if the truck bed floor has been distorted downward from heavy use. If you use an overhead-
lifting device, it should be disconnected before squaring the center section across the frame, installing the
sideplates and torquing fasteners.
OVERHEAD LIFTING DEVICE
BEFORE INSTALLING
Ford (1980 - 1996)
3/4 & 1 Ton No Overload Springs
Ford (1997 - 1998)
3/4 & 1 Ton Trucks
Old Body Style and No Overload Springs
Ford (1980 - 1996)
3/4 & 1 Ton Trucks
with overload springs
Ford (1997 - 1998)
3/4 & 1 Ton Trucks
Old Body Style and With Overload Springs
Ford (1980 - 1996)
1/2 Ton Trucks
Model 1100R-1110R-1150R
Turnoverball
TM
Gooseneck Hitch Installation Instructions
B&W Trailer Hitches
1216 Hawaii Road/ PO Box 186
Humboldt, KS 66748
620.473.3664
800.248.6564
Fax:620.473.3766
www.turnoverball.com
Call or Email us for Installation Support
NOTE: We recommend reading instructions before beginning the installation.
WARNING: The tow vehicle’s towing capacities should under NO circumstances be exceeded.
Center Box (GNRC800)
ITEM
DESCRIPTION
QTY
6
Center Section
1
7
2-5/16" Ball
1
8
Latch pin Handle
1
Safety Chain Kit Bolt Bag
9
1/2” U-Bolt
2
10
Conical Springs
4
11
1/2” Lock Nut
4
5/16” X 3/4” Carriage Bolt
1
5/16” X 3/4” Cap Screw
1
5/16” Lock Nut
1
Mounting Kit Box (GNRM1100)
ITEM
DESCRIPTION
QTY
1
Driver Side Plate
1
2
Passenger Side plate
1
3
Front Crossmember
1
4
Rear Crossmember
1
Mounting Kit Bolt Bag
5
Pipe Spacer
2
1" X 2-1/2" Cap Screw
2
1" Flat Washer
2
1" Lock Washer
2
1” Finish Nut
2
1/2" X 1-1/2" Cap Screw
12
1/2” Flat Washer
18
1/2" Lock Washer
12
1/2" Finish Nut
12
NOTICE: This product was designed to fit vehicles in their original, “as manufactured” condition.
Compatibility with vehicles having replacement parts, or other modifications is not guaranteed.
Inspect vehicle for modifications before installation of this product.