B&W Trailer Hitches 1007R User Manual
Model 1007r, Before installing, Turnoverball
www.turnoverball.com
Call or Email us for Installation Support
Turnoverball
TM
Gooseneck Hitch Installation Instructions
Model 1007R
B&W Trailer Hitches
1216 Hawaii Road / PO Box 186
Humboldt, KS 66748
800.248.6564
Fax:620.473.3766
Chevy-GMC (2007-2014)
1/2 Ton with Boxed Frame
***LONG BED TRUCKS ONLY***
BEFORE INSTALLING
OVERHEAD LIFTING DEVICE
An overhead-lifting device, such as chain falls, engine hoist, or cable come-a-long, can be used to lift the center
section of the hitch in place. Lower a loop of rope or chain through the 4” hole in the truck bed floor and attach it to
the latch pin in the round hitch receiver tube in the center section. Use the lifting device to raise the center section
until the round hitch receiver tube that protrudes from the center section fits in the 4” hole in the truck bed floor.
Maintaining upward pressure may facilitate fastening the crossmember to the center section, especially if the truck
bed floor has been distorted downward from heavy use. If you use an overhead-lifting device, it should be discon-
nected before squaring the center section across the frame, installing the sideplates and torquing fasteners.
WARNING
Most trucks have FUEL LINES and/or BRAKE LINES and/or ELECTRICAL WIRES located along the frame rails where
B&W Turnoverball™ hitches install. Carefully examine the location of fuel lines, brake lines and electrical wires BE-
FORE INSTALLATION. Be certain you will not damage fuel lines, brake lines or electrical wires when positioning hitch
components, drilling holes and tightening fasteners. The fuel tank vent, located on top of the gas tank, can be easily
damaged during the installation of the hitch components. Care must be taken when positioning the front crossmem-
ber and center section components.
NOTE: We recommend reading instructions before beginning the installation.
WARNING: The tow vehicle’s towing capacities should under NO circumstances be exceeded.
Mounting Kit Box (GNRM1007)
ITEM
DESCRIPTION
QTY
1
Driver Side Plate
1
2
Passenger Side plate
1
3
Front Crossmember
1
4
Rear Crossmember
1
5
Sideplate Clamp
1
6
5-1/2” X 4-1/4 X 1/2” U-Bolt
1
Mounting Kit Bolt Bag
7
1/2" Retainer
2
8
1/2" Frame Bushing
2
9
1/2” Locking Strap
2
1/2" X 2" Carriage Bolt
2
1/2” X 1-1/2” Cap Screw
11
1/2" Finish Nut
11
1/2” Lock Washer
17
1/2" Flat Washer
13
O-Ring
1
Center Box (GNRC959N)
ITEM
DESCRIPTION
QTY
10
Center Section
1
11
2-5/16” Ball
1
12
Latch Pin Handle
1
Safety Chain Kit Bolt Bag
13
1/2” U-Bolt
2
14
Conical Springs
4
15
1/2” Lock Nut
4
5/16” X 3/4” Carriage Bolt
1
5/16” X 3/4” Cap Screw
1
5/16” Lock Nut
1
NOTICE: This product was designed to fit vehicles in their original,
“as manufactured” condition. Compatibility with vehicles having
replacement parts, or other modifications is not guaranteed. Inspect
vehicle for modifications before installation of this product.