B&W Trailer Hitches Turnoverball Model 1251 (Toyota) - Manual

Model 1251R
Turnoverball TM Gooseneck Hitch Installation Instructions
Toyota Tundra
(2000 - 2006) [email protected]
www.turnoverball.com
Call or Email us for Installation Support
Copyright 2011
B&W Custom Truck Beds, Inc.
ALL RIGHTS RESERVED 1251R 04 19 2011
Parts List
1 - Front Crossmember
2 - Rear Crossmember
3 - Center Section
4 - Drivers side sideplate
5 - Passenger side sideplate
6 - Safety Chain U-Bolts
7 - Latch Pin Handle
8 - 2-5/16” Ball
9 - Springs
10 - 1/2” Lock Nuts
STEP SEVEN
Retract the latch pin by pulling the handle out until it stops, and then sliding it toward the front of the
truck. Place the 2-5/16” ball (7) in the hitch receiver. Engage the latch pin by pulling the handle and then
sliding it rearward and back to the locking position. Be certain the latch pin passes through the holes in
the 2-5/16” ball and engages completely through the hitch receiver socket. Grease the square base of
the 2-5/16” ball on all sides.
STEP SIX
Hardware Kit
12-1/2” X 1 1/2” bolts
12-1/2” flat washers
12-1/2” lock washers
4-3/4” flat washers
4-3/4” lock washers
4-3/4” nuts
4-3/4”x2 1/2” cap screws
Safety Chain Kit
2-1/2” U-bolts
4-1/2” lock nuts
4-springs
1-3/8” x 3/4” cap screw
1-3/8” lock nut
B&W Trailer Hitches
1216 HWY 224 / PO Box 186
Humboldt, KS 66748
800.248.6564
620.473.3664
Fax:620.473.3766
WARNING: LATCH PIN WILL NOT FUNCTION PROPERLY IF HANDLE IS NOT INSTALLED CORRECTLY.
Install the handle from underneath the truck by inserting it through the slot in the end of the center section
toward the driver’s side rear tire as shown. Attach the handle to the latch pin as shown with the handle on the
“cab side” of the square tab welded to the pin. The head of the bolt must be on the handle side, and the lock nut
must be on the tab side. The tab is welded to the pin in an offset position so that the handle will be lined up over
the center of the pin. If the handle is fastened to the other side of the tab, the handle will not function properly.
When installed correctly
the latch pin may be
disengaged from the
ball by pulling on the
handle from the driver’s
side wheel well and
rotating the handle
clockwise.
NOTE: We recommend reading instructions before beginning the installation.
WARNING: The tow vehicle’s towing capacities should under NO circumstances be exceeded.