Auto Meter 4359 - Manual (Page 7)

Feed the two sender wires , (purple and black) coming from the sender harness, through the fire wall and attach them to the connector.
Secure the sender wire to appropriate places on the vehicle to prevent it from getting damaged by heat or any moving components.
Connect the sender and gauge harness, program the gauge.
DESCRIPTION PICTURE
Also depending on your setup, you may have to make an
adjustment to the linkage to allow for a clean transfer of
motion from the shift lever to the sender. That includes the
length of the linkage.
Make sure the offset in the linkage is adjusted to have the
mating surfaces (highlighted in blue) in the linkage, arm and
bracket as parallel as possible.
Attach linkage fasteners. Regardless of your particular
setup, below is a picture how the linkage gets attached
to the arm AND the bracket. Use the two provided plastic
washers, the 1/4 nut and screw.
IMPORTANT: Do NOT over tighten the fasteners and leave
small gaps (min 0.02"; max 0.05")
Connect the linkage to the arm and bracket:
12 MONTH LIMITED WARRANTY
Auto Meter Products, Inc. warrants to the consumer that all Auto Meter High Performance products will be free from defects in material and workmanship for a period of twelve (12) months from date of the
original purchase. Products that fail within this 12 month warranty period will be repaired or replaced at Auto Meter’s option to the consumer, when it is determined by Auto Meter Products, Inc. that the product
failed due to defects in material or workmanship. This warranty is limited to the repair or replacement of parts in the Auto Meter instruments. In no event shall this warranty exceed the original purchase price of
the Auto Meter instruments nor shall Auto Meter Products, Inc. be responsible for special, incidental or consequential damages or costs incurred due to the failure of this product. Warranty claims to Auto Meter
must be transportation prepaid and accompanied with dated proof of purchase. This warranty applies only to the original purchaser of product and is non-transferable. All implied warranties shall be limited in
duration to the said 12 month warranty period. Breaking the instrument seal, improper use or installation, accident, water damage, abuse, unauthorized repairs or alterations voids this warranty. Auto Meter
Products, Inc. disclaims any liability for consequential damages due to breach of any written or implied warranty on all products manufactured by Auto Meter.
SERVICE
For service send your product to Auto Meter in a well packed shipping carton. Please include a note explaining what the problem is along with your phone number. If you are sending product
back for Warranty adjustment, you must include a copy (or original) of your sales receipt from the place of purchase.
FOR SERVICE SEND TO: AUTO METER PRODUCTS, INC. 413 W. Elm St., Sycamore, IL 60178 USA (866) 248-6357
Email us at [email protected]
http://www.autometer.com
2650-1705-00 10/9/13 © 2013 Auto Meter Products, Inc.
The Super Bezel is a registered trademark of Auto Meter Products, Inc.