Sensor setup via dhcp (automa c ip confi gura on), Accessing the internal web pages – APG LOE Master Sensor user manual User Manual
Page 9

Rev. B, 1/12
LOE Series
9
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
Sensor Setup via DHCP (automa c IP confi gura on)
Connect the LOE to a network that provides access to the internet, and apply
power to the sensor. The COM LED should begin to fl ash once every 30
seconds, indica ng the DHCP is a emp ng to establish communica on with the
web site. Once communica on is established, the COM LED will illuminated.
NOTE: see Troubleshoo ng DHCP if COM LED con nues to fl ash from more than
2-3 minutes.
Accessing the Internal Web Pages
To access the sensor’s se ngs, open an Internet browser, and in the address
bar enter: loe_# where # is the sensor’s serial number beginning at the
fi rst whole number. For example if the serial number is L000001275, then
you would enter loe_1275 into the browser address bar. The following screen
should appear:
NOTE: if typing the loe_# does not work, it may indicate the DHCP has saved
a previous name for the IP assigned. Power down the sensor and have the
System Administrator delete this name from the DHCP server.
Next, click the “Home” bu on and use the following default login when
prompted:
Username:
admin Password:
password
NOTE: use the Security link on the main page to set the desired Username
and Password.