APG LOE Master Sensor user manual - Manual (Page 31)

Rev. B, 1/12 LOE Series
31
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
Heartbeat Alarm Se ngs
Label: sets the alarm label that will be included in the alert message tle.
Message: allows the user to enter a brief message that will be included in the
body of the email or text alert message.
Call Type: selects the type of alert message to be sent. If “None” is selected,
the alarm condi on will show on the website but no message will be sent.
Sent: (view only) shows the status of the Delay count (see Delay below).
Delay: sets the number of mes the alarm must ac vate before an alarm
message will be sent. Se ng the Delay to 0 will disable the alarm.
Auto Clear: when checked, the Delay count will reset to 0 and begin again at
the end of each cycle, resul ng in a new alert message each me the Delay
count is reached. If Auto Clear is unchecked, the alert message will be sent
when the Delay count is reached, but no further messages will be sent unless
the alarm condi on clears and then reac vates and is processed though the
Delay count fi lter. If the alarm condi on clears and Auto Clear is unchecked, an
“Alarm Clear” message will be sent to the contact.
Contact: selects the user to receive the alert message (based the email address
and/or cell phone number in their user profi le).
Adding a new contact to an exis ng alarm
If more than one contact needs to receive an email and/or text message alert, a
duplicate alarm must be added and assigned to the new contact. Simply select
the alarm you wish to duplicate, click on the “Copy” bu on, select the new
“Contact”, and click the “Add” bu on.