AMMCO 800 On-The-Vehicle Brake Lathe - Manual (Page 8)

2 • AMMCO 800 On-The-Vehicle Brake Lathe
O On n- -T Th he e- -V Ve eh hiic clle e
Features
• Axial (spindle) Runout Compensation Ability while
Lathe is in Motion
• Semi-automatic Operation
• Automatic Safety and Shut Down Systems
• Operational Status Light System
• Pivotal On-The-Vehicle Brake Lathe Positioning
• Quick Connect System
• Portable Stand System Low Center of Gravity
Reduces Chance of Falling Over
• Three 5-inch Diameter Caster Wheels that Lock for
800 Brake Lathe Storage
• Counter Balance Cylinder Fitted with Standard
Schrader Valve used to Adjust Lathe Height
• Telescoping Frame
• Locations for Chip Tray, Hub Adapter Set, and
Toolbox
• Chip Tray Features Special Ferris-wheel Basket
Design
• Four Piece Hub Adapter Set Covers most
Passenger Vehicles, including Light Trucks
• Toolbox Provides a Convenient Location to Store
Tools and Accessories on the Portable Stand
System
• 4 mm T-handle Socket Hex Wrench
• Chatter Bands
• Plastic Mirror
• Set of Positive Rake Insert Holders (shipped
installed)
• Package of Carbide Inserts
Specifications
Maximum/Minimum Rotor Thickness
1.62 inches (41 MM)
Maximum/Minimum Rotor Diameter
13.78 inches [350 MM]
Depth of Cut
.025 per Side
Spindle Speed
88 RPM
Carriage Feed Speed
.004 inches/rev. (Adjustable)
Motor
3/4 Horse, Capacitor Start, Totally Enclosed, Single
Phase, 115VAC 60Hz
Duty Cycle
15-minutes, 7 1/2 min. on and 7 1/2 off
Based on Normal Operation
Electrical Supply
115AC 60Hz 15AMP Capacity
Dimensions
42-in. x 42-in. x 48-in.
Shipping Weight
225 lbs.