AMMCO 3860 Drum & Disc Brake Lathe - Manual (Page 7)

Brake Lathes
AMMCO 3850, 3860 Brake Lathes • 1
Before You Begin
Receiving
The shipment should be thoroughly inspected as soon as it is
received. The signed bill of lading is acknowledgement by the
carrier of receipt in good condition of shipment covered by our
invoice.
If any of the goods called for on this bill of lading are shorted
or damaged, do not accept them until the carrier makes a nota-
tion on the freight bill of the shorted or damaged goods. Do this
for your own protection.
NOTIFY THE CARRIER AT ONCE if any hidden loss or damage
is discovered after receipt and request the carrier to make an
inspection. If the carrier will not do so, prepare a signed state-
ment to the effect that you have notified the carrier (on a spe-
cific date) and that the carrier has failed to comply with your
request.
IT IS DIFFICULT TO COLLECT FOR LOSS OR DAMAGE AFTER
YOU HAVE GIVEN THE CARRIER A CLEAR RECEIPT.
File your claim with the carrier promptly. Support your claim
with copies of the bill of lading, freight bill, invoice, and photo-
graphs, if available.
Although AMMCO's responsibility ceases upon delivery of the
shipment to the carrier, we will gladly assist in tracing lost ship-
ments. Our willingness to assist in every possible manner does
not make AMMCO responsible for collection of claims or
replacement of lost or damaged materials. Shipping damage
claims will not be handled under warranty.
Electrical Requirements
The lathe must be properly grounded to protect the operator
from shock. The lathe is equipped with an approved 3-conductor
cord and a 3-prong grounding type plug to fit the proper ground-
ing-type receptacle. Should an extension cord be required, use
3-conductor cords with 3-prong grounding plug and 3-prong
grounding receptacle properly rated to handle this electrical
power tool only. Do not modify a cord or plug to match a recep-
tacle; have a qualified electrician install an appropriate outlet to
match the lathe requirements. Repair or replace any worn or
damaged power cords immediately.
The lathe requires a single-phase power source of 115 VAC
(±10%), 60 Hz, fused at 15 A for proper operation.
Figure 1 - Power Cord Plug and Receptacle