AMMCO 3860 Drum & Disc Brake Lathe - Manual (Page 20)

14 • AMMCO 3850, 3860 Brake Lathes
Brake Lathes
Maintenance and
Service
All the caution, warning, and danger information, as
well as the general safety information contained in this
manual must be observed not only during lathe opera-
tion, but while performing maintenance and service
items too.
Proper maintenance and service is required to keep
this unit operating in a safe and efficient manner. In
addition to the specific maintenance items that are
listed here, the following general maintenance items
must also be done regularly:
1. Check all fasteners and keep them tight.
2. Check all electrical components for proper, tight
connections. Check wiring for exposed wires or dam-
aged connectors.
3. Check all safety equipment and components.
Verify that each item is in place or available for use as
described in this manual.
4. Check all instructional and warning information
labels and plates on the unit and make sure they are
properly attached and clearly visible.
5. Fix or replace any damaged or excessively worn
components.
Keep rags and gloves used during mainte-
nance and service away from the lathe when
procedures require turning the lathe on.
They may become entangled in the arbor or
spindle, and pull the operator into the lathe
causing personal injury.
Lubrication
The bare metal parts are coated with an oil-soluble
rust preventative. It is not necessary to clean the rust
preventative from these parts. Before using the lathe,
all bare metal parts should be wiped down with an oiled
rag. Use a light machine oil for the initial and daily wipe
downs. Do not oil the tool bar clamping surfaces on top
of the slides.
A. Use a soft bristled brush to clear away metal chips
and debris before lubricating parts.
B. Grease crossfeed and rotor lead screw with a hand
grease pump monthly. Grease fittings (2) are provided.
Note: Crossfeed should be in the fully inward position
during lubrication.
C. Lubricate the 1 inch drum lead screw monthly.
Apply a light coating of Motor Kote 100 to the lead
screw.
D. Keep the dovetail ways lightly oiled.
WARNING