AirLive WN-220ARM - Manual (Page 70)

4. Appendix
AirLive WN-220ARM User’s Manual 66
specific adapter. The installation steps listed below are applicable for all network
adapters.
1. Go to Start > Right click on “My Computer” > Properties.
2. Select the Hardware Tab.
3. Click Device Manager.
4. Double-click on “Network Adapters”.
5. Right-click on Wireless Card bus Adapter or your specific network
adapter.
6. Select Properties to ensure that all drivers are installed properly.
7. Look under Device Status to see if the device is working properly.
8. Click “OK”.
Q: What can I do if my Ethernet connection does not work properly?
A:
1. Make sure the RJ45 cable connects with the router.
2. Ensure that the setting on your Network Interface Card adapter is “Enabled”.
3. If settings are correct, ensure that you are not using a crossover Ethernet cable,
not all Network Interface Cards are MDI/MDIX compatible, and use a patch
cable is recommended.
4. If the connection still doesn’t work properly, then you can reset it to default.
Q: Something wrong with the wireless connection?
A:
A. Can’t setup a wireless connection?
I. Ensure that the SSID and the encryption settings are exactly the
same to the Clients.
II. Move the WiFi Broadband Router and the wireless client into the
same room, and then test the wireless connection.
III. Disable all security settings such as WEP, and MAC Address
Control.