AirLive WN-220ARM User Manual
Page 30
3. Configuration
AirLive WN-220ARM User’s Manual
26
3.
Connection Control: There are 3 modes to select:
(1)
Connect-on-demand: The device will link up with ISP when the clients send
outgoing packets.
(2)
Auto Reconnect (Always-on): The device will link with ISP until the connection is
established.
(3)
Manually: The device will not make the link until someone clicks the connect-button
in the Status-page.
4.
Maximum Idle Time: the amount of time of inactivity before disconnecting your PPPoE
session. Set it to zero or enable “Auto-reconnect” to disable this feature.
5.
PPPoE Service Name: Optional. Input the service name if your ISP requires it.
Otherwise, leave it blank.
6.
Assigned IP Address: It is required by some ISPs. (Optional)
7.
Maximum Transmission Unit (MTU): Most ISP offers MTU value to users. The default
MTU value is 0 (auto).
8.
NAT disable: The device would not send private IP to other LAN PC if you select
disable.