AirLive WN-220ARM User Manual
Page 28
3. Configuration
AirLive WN-220ARM User’s Manual
24
1. Activate WWAN for Auto-Failover: With this function enabled, when the Ethernet WAN
connection is broken, the device will automatically activate the WWAN connection and
keep you connected to internet with the alternative WWAN broadband service. Meanwhile,
if the device detected that the Ethernet WAN connection is recovered, your broadband
connection will be switched to use the Ethernet WAN service.
2. Host Name: Optional, required by some ISPs, for example, @Home.
3. ISP registered MAC Address: Enter MAC address of your ISP. (Optional)
4. Connection Control: There are 3 modes to select:
(1) Connect-on-demand: The device will link up with ISP when the clients send outgoing
packets.
(2) Auto Reconnect (Always-on): The device will link with ISP until the connection is
established.
(3) Manually: The device will not make the link until someone clicks the connect-button in
the Status-page.
5. NAT disable: The device would not send private IP to other LAN PC if
you select disable.