AirLive WHA-5500CPE-NT - Manual (Page 90)

6. Command Line Interface
AirLive WHA-5500CPE-NT User’s Manual 84
„ show upnp
‰ Purpose: Show UPnP information
‰ Example:
Command> show upnp
UPnP is disabled
„ show mac
‰ Purpose: show the MAC address table in MAC filter mode. This might
change to show the wireless MAC address of WHA-5500CPE-NT in future
firmware release
‰ Example:
Command> show mac
Filter Name MAC address
------------------------------------------------------
ailrive 00-4f-62-24-12-34
„ show mac filter
‰ Purpose: show mac address table in the Access Control List
‰ Example:
Command> show mac filter
Filter Name MAC address
-------------------------------------------------
hello 00-4f-62-24-12-34
airlive 00-4f-62-24-11-11
„ show mac filter mode
‰ Purpose: Show whether the current MAC address is enable or not
‰ Example:
Command> show mac filter mode
MAC filter mode: disable
„ show mac filter
‰ Purpose: show mac filter status with the filter name
‰ Example:
Command> show mac filter hello
Filter Name MAC address
---------------------------------------------------