AirLive WHA-5500CPE-NT User Manual
Page 141
11. Frequent Asked Questions
135
AirLive WHA-5500CPE-NT User’s Manual
please enable “WDS Dynamic” on Mikrotik’s “AP Bridge” mode. If using
WEP, please choose “Static Key Required” on the Mirkrotik setting. For
step-by-step example, please visit AirLive.com’s support page at:
ype “WHA-5500CPE-NT” at
the support search.
====================================================================
Question
:
When I plug in the POE cable and power adapter, the WHA-5500CPE-NT’s
power LED is not on?
Answer: Please make sure you have connected the PoE cable to the correct port on
the DC injector. Moreover, you should use an Ethernet cable with 4 twisted
pairs (CAT5 or better) for POE cable.
====================================================================
Question
:
I tried the Emergency Upgrade procedure. But it doesn’t work, why?
Answer: Please make sure the firmware file is renamed to “zImage” without any file
extension. The file name has to match exactly with the big capital “I”.
====================================================================
Question
:
Where is the signal survey function that displays the RSSI value continuously?
Answer: The “Signal Survey” function is inside the Site Survey function. You can
access from “Operation Mode -> Setup -> Site Survey” menu.