AirLive WHA-5500CPE-NT - Manual (Page 89)

6. Command Line Interface
83 AirLive WHA-5500CPE-NT User’s Manual
‰ Example:
Command> z_debug add ssid air1
„ z_debug reboot
‰ Purpose: reboot your WHA-5500CPE-NT
‰ Example:
Command> z_debug reboot
Rebooting...
„ z_debug set port radio1 11a
‰ Purpose: Set SSID and Channel. We recommend using set commands
instead;
„ set ssid : to set the ssid name
„ set rate mode : set radio mode to 11a | supera_no_turbo
| supera_static_turbo.| supera_dynamic_turbo
‰ Example:
Command> z_debug set port radio1 11a air2 64
6.3 Show Commands
Show Commands are command that show the settings and status of WHA-5500CPE-NT
„ show arp table
‰ Purpose: Show ARP Table
‰ Example:
Command> show arp table
IP address Flags HWaddress Device
--------------------------------------------------------------------------------------------
192.168.1.100 C 00:1D:60:5E:AE:A0 lan
„ show http
‰ Purpose: Show HTTP service settings
‰ Example:
Command> show http
HTTP service port: 80
HTTP session timeout: 10 minutes