AirLive WH-5420CPE - Manual (Page 69)

66
Please follow the step below to create a new policy ―VIP‖
1.
Enter ―VIP‖ for the ―PolicyName‖
2. Enter ―512‖ for the ―LAN Out Rate‖
3.
Enter ―1024‖ for the ―WLAN Out Rate‖
4.
Enter ―VIP Subscriber‖ for the ―Comment‖
5. Click on ―Save‖ button
6. Now the ―VIP‖ policy will show up in the ―Current Policy Table‖
Once finished, the administrator will be able to choose the policy ―VIP‖ for their IP/MAC
Traffic Control.
C. Bandwidth Control by IP address
You can set the maximum bandwidth of a PC or a subscriber by using the IP Control.
Please follow the procedure below to setup IP Traffic Control
1. Please
make sure the ―Interface Traffic Control‖ is disabled
2. Before you start, please check the following area to see which client IPs are supported.
It differs between each mode.
3. Enable the IP Control
4. If you have defined a Policy already, please choose a P
olicy name. The ―Out Rates‖
will be automatically pasted from the Policy template. You cannot change the Out
Rates if you have chosen a Policy
Please check this part to find out what IP addresses
are supported. It varies between each mode