AirLive WH-5420CPE - Manual (Page 68)

65
A. Interface Control Settings:
In the Interface Control Settings, the AP only controls the total bandwidth limit of an
interface. For example, if you want to limit the output data rate of the LAN to 512K and the
output data rate of WLAN to
1024K. You should perform the
following steps:
1. Enable the ―Interface
Traffic Control
2.
Enter ―512‖ in the ―LAN
Output Rate‖
3. En
ter ―1024‖ in the
―WLAN Output Rate‖
4. Click on ―Save‖
5. Reboot the AP.
B. Define Policy
A policy is a set of bandwidth rules that can be
used as a template. For example, if you want to
provide 2 kinds of bandwidth speed to the users:
 VIP Subscriber:
 LAN Out Rate: 512 Kbps
 WLAN Out Rate: 1024 Kbps
 Regular Subscriber:
 LAN Out Rate: 64 Kbps
 WLAN Out Rate: 512 Kbps
You can configure the bandwidth rule as policies ―VIP‖ and ―Regular‖.