AirLive NVR4 - Manual (Page 50)

5. System Setup
AirLive NVR User’s Manual 45
static IP address if there is no DHCP server currently presented in the network. Its DHCP
server function is also turned on at the same time to assign IP addresses to cameras that
are later connected to the network. You can manually turn off the DHCP server function if
you wish to use a separate DHCP server.
Note: Change the NVR’s IP address would require the NVR to restart. Restart the device
under “system Options” “Maintenance” for the settings to take effect.
5.1.2 Time and Date
Set the time and date by selecting the time zone according to your location. It is imperative
that you set the NVR’s time correctly to avoid the following errors:
Incorrect display time for playback videos.
Inconsistent display time of event logs and when they actually occur.
After selecting the time zone, choose an option below to set the NVR’s time.
a. Manual – Use the drop-down list and configure the time manually
b. Sync with NTP server – enter the hostname or IP address of a valid NTP server and
set how often the NVR should synchronize the time with it by using the “Update interval”
drop-down menu
c. Sync with PC – Check this option to synchronize the NVR time with the PC that you
are currently using to access the NVR