AiM MyChron3 Basic - Manual (Page 26)

26
To run this function, after having entered the CONFIGURATION
MODE, push MENU/<< until you see:
NUMBER OF SPLITS
Now push MEM to enter EDIT MODE, then press MENU/<<
until the correct number of splits appears on the display’s lower
right corner.
Press MEM to save the changes or VIEW to discard the
changes.
Total Engine
running time
This function shows the total engine working time, which will be
displayed in hours and minutes, and lets you clear that data.
To run this function, after having entered the CONFIGURATION
MODE press button MENU/<< until you see
TOTAL RUNNING
To confirm your selection press MEM a second time: the
sentence “Total are cleared” will appear on the display. Press
VIEW to exit without deleting total running time
Temperature
alarm
This function sets the threshold temperature for the
thermocouple sensor that triggers the alarm when a dangerous
temperature has been reached. You should consult with your
engine manufacturer to determine what temperature threshold
should be set for your engine and thermocouple sensor.
To run this function, after having entered the CONFIGURATION
MODE, push MENU/<< until you see
TEMPERATURE ALARM