Installing the underspark thermocouple – AiM MyChron3 Basic User Manual
Page 20
20
Installing the Underspark thermocouple
When using a Cylinder Head Thermocouple ( CHT ) sensor, always remove the
spark plug washer before inserting the spark plug into the sensor.
When tightening and loosening the spark plug, minimise movement of the sensor
to avoid damage.
The following drawing shows the correct installation of the underspark
thermocouple.
See also other documents in the category AiM For the car:
- MXL (45 pages)
- Plug & Play Kit MXL Subaru (28 pages)
- MXL2 (22 pages)
- MXG (22 pages)
- Solo (21 pages)
- MyChron4 User manual (24 pages)
- MyChron4 Quick guide (8 pages)
- MyChron4 2T (4 pages)
- MyChron4 660 (87 pages)
- EVO4 (28 pages)
- ECU Bridge (18 pages)
- RPM Bridge (12 pages)
- GT Steering Wheel (24 pages)
- Formula Steering Wheel (20 pages)
- G-Dash (20 pages)
- MXL Dash (10 pages)
- GPS05 Module (32 pages)
- MyChron Expansion (16 pages)
- LCU-One CAN + Analog ver 1.05 (36 pages)
- LCU-One CAN for MyChron4 (12 pages)
- LCU-One CAN for MyChron4 660 (10 pages)
- LCU-One CAN for MXL/EVO3 (16 pages)
- LCU-One CAN for MXL QM/EVO3 QM (22 pages)
- LCU-One Analog ver 1.02 (16 pages)
- Data Hub (9 pages)
- Data Key (4 pages)
- Channel Expansion (7 pages)
- TC Hub (9 pages)
- MyChron3 Plus (91 pages)
- MyChron3 Visor (4 pages)
- MyTach (39 pages)
- SportsAgenda (38 pages)