2N NetStar User Manual - Manual (Page 42)

42
hold and the other subscriber hears the Music on Hold. By re–pressing 7* you swap the
two calls.
Active Call Termination
Basically, there are two situations in which you can use this service. In the first case
you have one call on hold and want to terminate the current call, and in the other case
you have an active call and want to dial another destination after terminating the
active call.
9#
Return to Call on Hold with Active Call Termination
When you have put a call on hold and want to terminate the active call to return to the
one on hold, use the Active Call Termination service. Using this service you disconnect
the active call (the opposite party hears the busy tone) and get connected to the call
on hold.
Example: Suppose that two calls have been established on your Mobility Extension
(both via ). One of the calls is on hold (the subscriber hears the Music on 2N NetStar
®
Hold). To terminate the active call and get through to the call on hold, dial the code
9#.
Active Call Termination with Further Dialling
The case is quite different if you have established one call only and want to terminate
it. After a standard hang–up, you have to call the communication system 2N NetStar
®
for a new call. To save the call setup costs, use the Active call Termination service.
Example: Suppose you have established just one call on your Mobility Extension and
want to terminate it to be free for another internal call. Press 9# during the call. The
current call is disconnected and you get the communication system dialtone again. Dial
the next subscriber number and a call will be set up like the first call.