2N NetStar User Manual - Manual (Page 35)

35
5.1 Time and Date Setting
To set date and time, use either the administration console or the 2N NetStar
®
2N
®
application. In either case, you have to know the login name and NetStar Assistant
password of the user with administrator rights. Another possibility is to use the
dedicated services.
Set TIME
This service helps you set the communication system time simply by using your phone.
Dial:
*51 hhmm
where hh represents hours and mm minutes. Single-digit parameters are entered with
a zero.
Example: Suppose you want to change the communication system time to 8:15. After
lifting the handset and hearing the dialtone, enter the service access code *51. You will
be asked to enter the new time value. Enter 0815 and, after receiving the last digit and
playing a message on the time change, the communication system disconnects the call.
The time has been successfully set.
The service will not work in case time synchronisation from the NTP
server is enabled in your communication system.
Set DATE
This service helps you set the communication system date simply by using your phone.
Dial:
*52 ddmmrrrr
where dd represents days, mm months and yyyy years. Single-digit parameters are
entered with a zero.
Example: Suppose you want to change the communication system date to June 5,
2007. After lifting the handset and hearing the dialtone, enter the service access code
*52. You will be asked to enter the new time value. Enter 05062007 and, after
receiving the last digit and playing a message on the date change, the communication
system disconnects the call. The date has been successfully set.