2N NetStar User Manual - Manual (Page 13)

13
3.1 Call Transfer
Are you talking with a subscriber and do you want to transfer the call to another
subscriber? Then you can do so in one of the following ways. In all the cases it does
not matter who initiated the original call (the caller or the person called).
Call Transfer with Hang-Up
Push FLASH during the call and dial the subscriber number. The other party hears
music (or a predefined voice message) while waiting for connection.
If you hear the ringing tone after dialling, you can hang up. This transfers the call to
the selected subscriber and the caller hears the ringing tone instead of music.
If you hear the busy tone after dialling, the call cannot be transferred as the selected
subscriber is busy (or the communication system has rejected the call for other
reasons). You can return to the caller by pressing FLASH on your phone and complete
the call. Or, you can transfer the call to another subscriber, put the call on hold by
pressing the HOLD button, or park it (Call Parking, chapter 3.2). Dial:
F nn
where F is FLASH and nn is the number of the subscriber you want to transfer the call
to.
Unless answered by the other subscriber within a timeout, the call
returns to the transfer-initiating user and alerts his or her station.
Call Transfer without Hang-Up
Push FLASH during the call and dial the subscriber number. The other party hears
music (or a predefined voice message) while waiting for connection.
If you hear the ringing tone after dialling, wait until the called subscriber answers and
then either hang up to transfer the call, or push the FLASH button on your phone to
return to the original call (the second call is thus put on hold and the subscriber hears
music or a voice message).
If you hear the busy tone after dialling, you cannot transfer the call as the selected
subscriber is busy. Repress the FLASH button on your phone to return to the original
subscriber and complete the call. Or, transfer the call to another subscriber, push the
HOLD button to put the call on hold, or park the call (Call Parking, chapter 3.2). Dial:
F nn
where F is FLASH and nn is the number of the subscriber you want to transfer the call
to.