2N NetStar User Manual - Manual (Page 31)

31
4.4 PIN Setting
This service helps you set and change the PIN. The PIN can be set from any user
station and is identical for all of the user stations. It is used for some of the 2N
®
services and has to be entered by the user if requested so by the system. If NetStar
not requested, the services can be used without the PIN. The default PIN for all users is
1111.
If the PIN setting procedure is successful, the communication system confirms the new
PIN with a message. If not, you are notified of having entered an incorrect PIN on each
step and invited to re-enter the PIN. The third erroneous attempt is followed by PIN
setting termination. The PIN should consist of four digits. If shorter, push an asterisk
for termination.
Change PIN
*70 old new new
Delete PIN
*70 old*
Set New PIN after Deletion
*70 new new
Example: Suppose you want to change your old PIN 1111 to a new one 9876. After
lifting the handset and hearing the dialtone, enter the service access code *70. You will
be asked to enter the old PIN, so enter 1111. The communication system will then ask
you for the new PIN, so enter 9876. The communication system will now ask you to
repeat the new PIN, so re-enter 9876. If the PIN setting procedure is successful, the
communication system will confirm the new PIN setting. From now on you should only
use the new PIN for secured services.
If you delete your PIN as described above and fail to enter a new one,
you will not be able to use any of the PIN-secured services!!!