2 intercom control as viewed by external user, Quick dial buttons, Calling to phone book position – 2N Helios IP Verso User Manual

Page 97: Calling to user-defined phone number

1.
2.

3.2 Intercom Control as Viewed by External User

Quick Dial Buttons

Press the quick dial button on the basic unit to dial the first position in the phone
directory (Phone Book) depending on the model type. Use extending modules to
extend the number of quick dial buttons to up to 146.

By pressing the quick dial buttons you dial the phone numbers assigned to the
particular Phone Book position. Call setup is signalled by a long intermittent or any
other tone depending on the configuration of the PBX connected.

Repeated pressing of one and the same quick dial button during call setup may initiate
call hangup or call termination plus dialling the next phone number of the called
subscriber, or may be assigned no function; refer to the Intercom Configuration /

Hardware / Keyboard subsection of Configuration Manual

You can also press the

button anytime to hang up if enabled so in the Hang up by

parameter; refer to the

Intercom Configuration / Hardware / Keyboard subsection of

Configuration Manual

Calling to Phone Book Position

The

Phone Book can contain up to 999 programmable positions.

Helios IP Verso

The quick dial buttons can only be used for positions 1 through 146, depending on the
number of actually installed buttons. You can dial the other positions using the numeric
keypad if the

function is enabled; refer to the

Quick dialling with digits

Intercom

Configuration / Hardware / Keyboard subsection of Configuration Manual

Procedure:

Enter the position number using the numeric keypad (05, 15, 200, e.g. – two

digits at least and four digits at most) and press the

button for confirmation.

You can also press the

button anytime to hang up if enabled so in the Hang

parameter; refer to the

up by #

Intercom Configuration / Hardware / Keyboard

subsection of Configuration Manual

Calling to User-Defined Phone Number

If the

(refer to the

Telephone function enabled

Intercom Configuration / Hardware /

) parameter is selected, you can dial a

Keyboard subsection of Configuration Manual
user-defined phone number using the

numeric keypad.

Helios IP Verso

Procedure:

Press

You will hear a continuous tone from the speaker.

Enter the phone number via the numeric keypad and press

again to confirm

your dialling.

You can also press the

button anytime to hang up if enabled so in the Hang