2N Helios IP Verso - Manual (Page 96)

96
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Dynamic/Static IP Address Switching
Take the following steps to switch the dynamic and static IP address mode in 2N
®
: Helios IP Verso
Connect (or, if connected, disconnect and reconnect) to 2N
®
Helios IP Verso
the power supply.
Wait for the first sound signal .
Press the quick dial button on the basic unit 15 times.
Switching is signalled with the sound signal .
Wait until the device is restarted automatically.
Upon restart, the static IP address mode will be switched to the dynamic IP
address mode and vice versa.
The following network parameters will be set after the static IP address mode is
switched on and the device is restarted:
IP address: 192.168.1.100
Network mask: 255.255.255.0
Default gateway: 192.168.1.1
Note
Be sure to press the button sequence within thirty seconds after the
sound signal for security reasons. Up to 2 s intervals are allowed between
the presses.
Note
Be sure to press the button sequence within thirty seconds after the
sound signal for security reasons. Up to 2 s intervals are allowed between
the presses.