2N Helios IP Verso - Manual (Page 101)

101
2N TELEKOMUNIKACE a.s., www.2n.cz
®
3.4 Intercom Control as Viewed by Internal User
Call Answering
You can answer the incoming calls to the intercom using your 2N
®
Helios IP Verso
phone like any other calls. You can unlock the door, activate/deactivate a user/profile
via your phone keypad during the call. The calls, however, are time-limited to avoid
unintentional blocking of the
line. Set the maximum call 2N
®
Helios IP Verso
duration in the (refer to Call time limit the Intercom Configuration / Services / Phone
). Press # on your phone anytime to extend / Calls subsection of Configuration Manual
the call time. The automatic call termination is signalled with a short beep 10 s before
the call end.
Calling to 2N
®
Helios IP Verso
2N
®
Helios IP Verso allows you to answer incoming calls. Set the required
parameters in the Incoming calls group; refer to the Intercom Configuration / Services
/ Phone / Calls subsection of Configuration Manual.
Door Opening (Switch Activation) by Code
2N
®
Helios IP Verso is equipped with a door unlocking switch. Enter the valid code
(refer to the Intercom Configuration / Hardware / Switches subsection of Configuration
) using your phone keypad to activate this switch. Manual
Procedure:
Enter the switch 1 or 2 activating code using your phone keypad and press for
confirmation. Confirmation is unnecessary if the Lock code without
is enabled, refer to the confirmation Intercom Configuration / Hardware /
. Switches / Advanced subsection of Configuration Manual
A valid code is signalled by the sound. An invalid code is signalled by the
sound.
User Activation/Deactivation
Activate/deactivate a user using your phone in order to route calls directly to the phone
numbers assigned to the user, refer to the Intercom Configuration / Directory / Phone
for details. Book subsection of Configuration Manual
Procedure:
Enter the user activating/deactivating code using your phone keypad and press
for confirmation.
A valid code is signalled by the or according to the code type. An
invalid code is signalled by the sound.