Setcamerainput, Controlrtpstream, Action.setcamerainput – 2N Helios IP Automation Manual v2.8 User Manual
Page 26: Action.controlrtpstream, Parameters, Example
26
Action.SetCameraInput
The
block defines the action that switches the video signal sources –
SetCameraInput
either the integrated video camera or an external IP camera, or two inputs for
analogue camera connection to the
.
2N Helios IP Video Kit
®
Parameters
Event – define the event to launch this action.
Condition – define the condition to be met for the action to be executed. This
parameter is optional.
Type – define the video signal type. A change during a call will apply only for this
call. Other video receivers receive video from the same source
.
Valid values:
internal – internal camera (or external analogue video camera
connected directly to the device)
external – external IP camera.
The parameter is optional, the default value is
.
internal
Id – define the video signal channel. The parameter is available with the 2N
®
Helios IP Video Kit model only and applicable only if the Type parameter is set to
.
internal
Valid values:
1 – analogue camera connected to input 1
2 – analogue camera connected to input 2
The parameter is optional, the default value is .
1
Example
Switch the video signal source to the first external analogue camera input if the event
defined on row 2 arises:
Action.SetCameraInput: Type=internal; Id=1; Event=2
Action.ControlRtpStream
Block
defines the action that controls the flow of the RTP streams.
ControlRtpStream
This action controls only call streams; multicast streams are not affected by this action.