Google Postini Directory Sync Configuration Guide - Manual (Page 63)

Sun ONE Directory Server 63
Install DSML
Enable DSML through the Directory Server console.
1. Log into the directory server console. Start the console from the directory
where your Sun ONE Directory Server is installed. You will need root
privileges.
# ./startconsole
2. On the top-level Configuration tab of the Directory Server console, select the
root node in the configuration tree, and select the Network tab in the right-
hand panel.
3. Check Enable DSML.
4. Select Only secure port.
If this option is not available, you need to activate and enable SSL.
5. Enter the port number for SSL. The default SSL port is 443. If you decide to
use a port other than 443, write the port number down so you can refer to it
later. Note that unlike LDAP queries, DSML queries use port 443, and an
HTML connection.
6. Enter the full relative URL. Set the path name to “/dsml”. The full relative URL
includes the path name, combined with the host and the port number.
7. Click Save.
8. Restart the directory server.