Google Postini Directory Sync Configuration Guide - Manual (Page 42)

42 Configuration Guide for Directory Sync
6. Install DSML
7. Collect information for Directory Sync setup
Each of these steps is documented in a separate section below.
Enable LDAP support on your DSML Server
LDAP service is not enabled by default in a Lotus Domino server. To enable
LDAP services on an existing Domino server, load LDAP support and create a
server configuration document.
Load LDAP support in a Domino Server
1. In the Domino server command prompt, enter the following:
load LDAP
2. Open the notes.ini file. Add LDAP to the end of the line starting with
“ServerTasks=” and save the file.
3. If you are using a partitioned server, add the text
LDAPAddress=[IP Address]
to a new line, where [IP Address] is the IP address for the partition that is
running the LDAP server.
Create a server configuration document
To make configuration changes to your LDAP server, you will need to create a
server configuration document.
1. From the Administrator client, click the Configuration tab, expand the Server
section, and click the Configurations icon.
2. Click Add Configuration to create a new configuration document.
3. Check the box marked “Use these settings as the default settings for all
servers”. You can only have one default document.
4. Click the LDAP tab to view LDAP configuration settings.
The screen should look like the picture below.