Warning – JLG G10-43A (0160005444 & After) Operator Manual User Manual
Page 146

Section 7 - Lubrication and Maintenance
7-18
31200150
E. Wheel Installation
Torque lug nuts after first 100 hours and after each wheel installation.
Note: If machine is equipped with directional tire assemblies, the wheel and tire
assemblies must be installed with the directional tread pattern “arrows” facing in the
direction of forward travel.
1. Start all nuts by hand to prevent cross threading. DO NOT use a lubricant on
threads or nuts.
2. Tighten lug nuts in an alternating pattern as indicated in figure. Torque to
350-400 lb-ft (475-542 Nm).
WARNING
TIP OVER HAZARD. Lug nuts must be installed and maintained at the proper
torque to prevent loose wheels, broken studs and possible separation of wheel
from the axle.
OY1220
1
2
3
4
5
6
7
8
9
10
This manual is related to the following products: