JLG 1350SJP Service Manual - Manual (Page 477)

SECTION 6 - JLG CONTROL SYSTEM
3121142 – JLG Lift – 6-101
8441 84 41 TOWER CYLINDER ANGLE MOVEMENT WITHOUT COMMAND The Tower Cylinder Angle Sensor
is changing without a tower lift
command. - Envelope Control equipped vehi-
cles only.
-1250
8442 84 42 MAIN TRANSPORT ANGLE SWITCH FAILED The Main Boom Angle Switch is
bad. - Envelope Control equipped vehi-
cles only.
-1250
8443 84 43 TWR TRANSPORT SWITCH DISAGREEMENT There is a disagreement
between the Tower Boom
Length Switch and the Tower
Length Sensor. - Envelope Control equipped vehi-
cles only.
-1250
8444 84 44 TRANSPORT DUAL CAPACITY SWITCHES BAD Both the Dual Capacity Switch
and the Transport Switch are
bad. - Envelope Control equipped vehi-
cles only.
-1250
8445 84 45 TRANSPORT DUAL CAPACITY BAD TRANSITION The Dual Capacity Switch and
the Transport Switch changed
state out of order. - Envelope Control equipped vehi-
cles only.
-1250
8446 84 46 MAIN TRANSPORT LENGTH SWITCH DISAGREEMENT There is a disagreement
between the Main Boom Trans-
port Length Switches. - Envelope Control equipped vehi-
cles only.
-1250
8447 84 47 MAIN DUAL CAPACITY LENGTH SWITCH DISAGREEMENT There is a disagreement
between the Main Boom Dual
Capacity Length Switches. - Envelope Control equipped vehi-
cles only.
-1250
8448 84 48 MAIN TRANSPORT ANGLE SWITCH/SENSOR DISAGREEMENT There is a disagreement
between the Main Boom Angle
Switch and the Main Boom
Angle Sensor. - Envelope Control equipped vehi-
cles only.
-1250
8449 84 49 TOWER CYLINDER ANGLE SWITCH/SENSOR DISAGREEMENT There is a disagreement
between the Tower Boom Angle
Switch and the Tower Cylinder
Angle Sensor. - Envelope Control equipped vehi-
cles only.
-1250
8450 84 50 NEW MAIN ANGLE SENSOR #1 DETECTED A new Main Angle Sensor 1 has
been detected. -1250
8451 84 51 NEW MAIN ANGLE SENSOR #2 DETECTED A new Main Angle Sensor 2 has
been detected. -1250
8452 84 52 TOWER LENGTH SWITCH/SENSOR DISAGREEMENT There is a disagreement
between the Tower Length
Switch and the Tower Length
Sensor. - Envelope Control equipped vehi-
cles only.
-1250
8453 84 53 WRONG MAIN TELE RESPONSE Main telescope is moving in the
opposite direction of the com-
mand. - Envelope Control equipped vehi-
cles only.
-1250
8454 84 54 WRONG MAIN LIFT RESPONSE Main lift is moving in the oppo-
site direction of the command. - Envelope Control equipped vehi-
cles only.
-1250
8482 84 82 TOWER ENVELOPE MASSIVELY ENCROACHED X
8483 84 83 TOWER ENVELOPE MULTIPLE ENCROACHMENTS X
Table 6-6. Diagnostic Trouble Code Chart
DTC
Flash
Code
Sequence Fault Message Fault Description Check