JLG 1350SJP Service Manual - Manual (Page 419)

SECTION 6 - JLG CONTROL SYSTEM
3121142 – JLG Lift – 6-43
ENVELOPE: Displayed if MODEL NUMBER = 7 or 8
LENGTH XXXX.X Displays the current indicated boom length in inches.
ANGLE 1 XX.X Displays the current indicated boom angle 1 in degrees.
ANGLE 2 XX.X Displays the current indicated boom angle 2 in degrees.
A/D LNGTH XXXXX Displays the current indicated boom length in A/D counts.
A/D ANG1 XXXXX Displays the current indicated boom angle 1 in A/D counts or raw angle if cali-
brated.
A/D ANG2 XXXXX Displays the current indicated boom angle 2 in A/D counts or raw angel if cali-
brated.
CAN STATISTICS: CAN Statistics as detected by the Ground Module
RX/SEC XXX Displays the number of received messages per second
TX/SEC XXX Displays the number of transmitted messages per second
BUS OFF XX Displays the number of bus off occurrences
PASSIVE XX Displays the number of bus passive occurrences
Table 6-5. Machine Diagnostics Parameters
Diagnostics Submenu
(Displayed on Analyzer
1
st
Line)
Parameter (Displayed on
Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2
nd
Line)
Description