Eppendorf Innova 40R Shaker - Manual (Page 35)

Operation
New Brunswick Innova 40/40R Shaker
English (EN)
35
The LCD will display Process Running — Saving Profile for a few seconds and then return to the main
PROG screen.
5.11.3 Edit a program
Use the Edit mode to open a program you have already created and saved, in order to modify your settings
following the same procedures.
5.11.4 Run and stop a program
Use the Run mode to turn a specific program on. Only one program can run at a time. When you change the
mode to Run , the screen will show the Run icon (see Fig. 5-2 on p. 22).
To stop a program, change the program mode to Off .
5.12 Program the timer
By setting an HRS setpoint in the DISP or SUMM screen, the shaker may be set to automatically stop after a
preset time period of 0 hr 1 min – 99 hr 59 min.
If the time is set to 0:00 , the shaker will operate continuously until either the lid is opened or the Start/Stop
switch is pushed.
5.13 Power interruption
In the event of a power failure, the Innova 40/40R Shaker is equipped with an automatic restart function.
The shaker's non-volatile memory retains all stored information.
If the shaker was in operation prior to the power interruption, the shaker will begin to operate at its last
entered setpoints. The alarm
POWER will flash on the display, indicating that a power interruption has
occurred. Turn the Control knob in any direction to acknowledge the visual alarm. The flashing will stop.