3 creating the temperature offset, 4 calibrating the shaking speed, 11 programs screen – Eppendorf Innova 40R Shaker User Manual
Page 32: Creating the temperature offset, Calibrating the shaking speed, Programs screen, Programs screen on p. 32)

Operation
New Brunswick Innova 40/40R Shaker
English (EN)
32
5.10.3
Creating the temperature offset
In the
CAL
screen:
5.10.4
Calibrating the shaking speed
The Innova 40/40R Shaker is calibrated at the factory. The speed does not need to be recalibrated until a
major operating component (e.g. a drive belt) is changed. This should be done by a qualified service
technician.
5.11
Programs screen
Use the
PROG
screen to program steps for the shaker. The resident software for the Innova 40/40R Shaker
can store up to four programs, each having as many as 15 steps. Each step can be programmed in 1
min
increments, for total periods of 0
hr
1
min
–
99
hr
59
min.
To enter the programming mode, use the
Control knob to select the
PROG
screen.
In the
PROG
screen you can:
•
Run
a program.
• Create a
New
program.
•
Edit
a program.
• Turn
Off
a program.
Abb. 5-8: Program screen
Fig. 5-8:
Program screen
1. Calculate the temperature offset value to plug in
Calculating the temperature offset on p. 31).
2. Turn the
Control knob
to select the
°C Offset
value
(
0.0
in figure).
3. Enter the
°C offset
desired.
m
r
i
h
c
s
d
li
B
:
9
.
b
b
A
PROGRAMS