Eppendorf ThermoMixer C - Manual (Page 16)

16
Installation
Eppendorf ThermoMixer
® C
English (EN)
4 Installation
4.1 Selecting the location
Select the device location according to the following criteria:
• Mains/power connection in accordance with the name plate
• Minimum distance to other devices and walls:10 cm (3.9 in)
• Resonance free table with horizontal even work surface
• The design of table is suitable for operating the device.
• The design of table is suitable for operating the device.
• Surrounding area must be well ventilated.
• The location must be protected against direct sunlight.
4.2 Installing the instrument
1. Place the ThermoMixer C on a suitable work surface.
Position the device in such a way that the ventilation slots of the device are not
obstructed.
2. Connect the power cable to the power connection socket of the device and the power
supply.
The mains/power switch and cutting unit of the mains/power line must be easily
accessible during operation (e.g, residual current circuit breaker).
WARNING! Risk from incorrect supply voltage

Only connect the device to voltage sources which correspond to the electrical
requirements on the name plate.

Only use sockets with a protective earth (PE) conductor and suitable power
cable.