Advance Adapters 715543231 - Manual (Page 8)

ADVANCE ADAPTERS INC. P/N: 715543-231
P.O. Box 247, 4320 Aerotech Center Way New Item: (10/10)
Paso Robles, CA 93447 PAGE 8 of 8
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 10-11-10
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we
strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
TJ 231 CABLE SHIFTER
Barrel Mount
Transfer Case Installation and Transfer Case Shifter Cable Gear Box End Adjustment:
1. Bolt the transfer case shifter bracket to the front of the transfer case where the stock bracket was bolted.
2. Route the transfer case shifter cable through the transfer case shifter bracket hole with a jam nut on both
sides of the bracket and then completely thread the heim joint on to the end of the cable and tighten the
jam nut. This cable should already be routed under the transmission cooler lines.
3. Remove the tranfer csae shift lever.
4. Install the new supplied shift lever with the original nut (use a medium strength thread locking compound
on the threads) and see Figure 29 for correct lever orientation. Torque to 20 ft-lbs.
5. Adjust the transfer case shifter cable by adjusting the two 5/8" nuts so that the heim travels an 1/8" past the
shift lever for both directions of travel.
6. Attach the cable shifter heim to the previously installed shift lever (See Figure 29) using the supplied 1/4-
20x1" hex head bolt and a nylock hex nut.
7. Check the position of the lever through the console,
adjustments can be made by adjusting the cable
barrels below the shifter box assembly. The transfer
case shift lever should change to approximately. 1.25"
from the console after installation and final adjustment.
Figure 29: New Transfer Case
Shift Lever Orientation