Advance Adapters 715543231 - Manual (Page 2)

ADVANCE ADAPTERS INC. P/N: 715543-231
P.O. Box 247, 4320 Aerotech Center Way New Item: (10/10)
Paso Robles, CA 93447 PAGE 2 of 8
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 07-14-11
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we
strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
TJ 231 CABLE SHIFTER
The Igus bushings must be pressed into the shift handle. A arbor press or a light hand
with a hammer works well. Once the bushings are installed the pivot pin gets installed
through the handle.
Install the wave washer and spacer, then the pivot pin mounts.
Once both pivot pin mounts are installed, use the #6 set screws to lock them to the pivot pin. The pivot pin should be
flush with the outside edge of the pin mounts. Install the handle assembly into the shifter housing making sure the handle
is pointing forward or in the same direction as where the cable will be mounted (see photo).