Advance Adapters 715543231 - Manual (Page 4)

ADVANCE ADAPTERS INC. P/N: 715543-231
P.O. Box 247, 4320 Aerotech Center Way New Item: (10/10)
Paso Robles, CA 93447 PAGE 4 of 8
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 10-11-10
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we
strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
Disassembly/Preparation For Assembly:
1. Use an Advance Adapters Uni-Raise (PN: 15-
1000) (See Figure 1) or some other device to
support the transmission pan to support its weight.
Take caution to avoid denting the pan and
damaging the transmission.
2. Remove the four M10 foot-mount nuts from the
crossmember.
3. Remove crossmember and any aftermarket skid
plates.
4. Remove front drive shafts. not manditory but helps to access the transfer case and linkage parts.
Interior Disassembly/Reassembly:
1. Remove the cup holder if it is removable, depending on the
style of your console. (See Figure 8)
2. Remove the transmission shift handle by grabbing firmly and
pulling straight up until it pops off.
3. Using a small flat head screw driver, remove the transmission
shift indicator cover. Once it pops loose you must disconnect
the light on the bottom side of the cover to completely remove
it. (See Figure 9 and 10)
4. Use a 10mm socket to remove the two console bolts located
under the cup holder and under the
shift indicator panel.
5. Move transfer case
handle to 4wd-Low and then pull
the console out.
TJ 231 CABLE SHIFTER
Figure 1: Uni-Raise
Figure 10: Indicator Light
Figure 9: Transmission Shift Indicator
Figure 8: Cup Holder Removal