Advance Adapters 713025-EK User Manual
Page 5

Page 5 of 11
Refer to diagram B and C.
This operation requires the slave cylinder push rod and clutch fork to be fitted.
6. Push the thrust bearing and carrier as far back as it will go. Measure the distance from
adaptor housing engine face (Dimension A) to the front of the thrust bearing.
This measurement should be 10-mm +-3-mm greater than the distance measured between
the engine rear face and the pressure plate fingers. Refer step I4.
7. Do not fit the input shaft extension to the transmission. This will make the engine
mount set up procedure easier.
This manual is related to the following products:
See also other documents in the category Advance Adapters For the car:
- 712500A4 (1 page)
- 712500A (1 page)
- 712500M (1 page)
- 712500T (1 page)
- 712502 (3 pages)
- 712505 (2 pages)
- 712506 (2 pages)
- 712508 (2 pages)
- 712510 (2 pages)
- 712511 (2 pages)
- 712512 (2 pages)
- 712512-T98 (2 pages)
- 712514 (2 pages)
- 712514-T98 (2 pages)
- 712516 (2 pages)
- 712517 (2 pages)
- 712518 (2 pages)
- 712519 (2 pages)
- 712521 (2 pages)
- 712522 (2 pages)
- 712523 (2 pages)
- 712527 (2 pages)
- 712528 (2 pages)
- 712529 (2 pages)
- 712530 (3 pages)
- 712532 (2 pages)
- 712533 (2 pages)
- 712534 (2 pages)
- 712541 (4 pages)
- 712543 (3 pages)
- 712544 (2 pages)
- 712543J (4 pages)
- 712548 (4 pages)
- 712549 (3 pages)
- 712550 (2 pages)
- 712551 (2 pages)
- 712552 (2 pages)
- 712553 (2 pages)
- 712555 (3 pages)
- 712559 (3 pages)
- 712560 (3 pages)
- 712560V (3 pages)
- 712561 (3 pages)
- 712561V (3 pages)
- 712562 (1 page)