beautypg.com

Advance Adapters 713025-EK User Manual

Page 4

background image

Page 4 of 11

Diagram A.

E.

1F, 2F, and early 3F fitted with the one-piece cast iron bellhousing.

1. Fit the adaptor housing assembly to the Toyota petrol bellhousing using the original

bolts.

2. Fit the bellhousing and adaptor assembly to the gearbox.

Cast iron clutch fork
3. Refit the clutch fork and retaining clips to the thrust-bearing carrier using the 2 clips

supplied in the kit.

4. Refit the slave cylinder.
5. Using silastic or a suitable gap sealer, seal the slot between the adaptor housing and

bellhousing. The slot is located on the driver side top of the housing. This hole was
once used as the timing inspection hole.

1

1

2

3

3

4

5

6

Pre 08/80 vehicles.

1. Fit the bellhousing rubbers and bolts but do not tighten them. This will make the

engine mount set up procedure easier.

This manual is related to the following products: