Advance Adapters 713025-EK User Manual
Page 3

Page 3 of 11
Slide the thrust bearing extension carrier through the inside of the adaptor housing.
Ensure that the tube slides in and out of the adaptor housing with ease. If the thrust
bearing extension tube is tight, you may need to clean any burs inside the housing with
light emery paper.
3. Fill with grease the groove inside the middle of the adaptor housing and refit the
thrust bearing extension tube.
4. Press the thrust bearing (SF0914) onto the front of the extension tube.
5. Fit the two 10-mm dowels (MFC197) into the gearbox end of the new adaptor
housing.
6. Now is a good time to check the condition of the gearbox-input bearing and front seal.
If faulty, replace them.
1. If your vehicle is fitted with a cast iron thrust-bearing carrier and fork.
2. There are two sets of flats machine into the new carrier the widest ones are used with
the cast iron fork.
3. Fit the bearing blocks (1) to the carrier (2) using the 4 x M4 counter sunk screws
supplied in the kit. NOTE: Use locktite on the screws.