Advance Adapters 713025-EK - Manual (Page 2)

Page 2 of 11
3F fitted with the Two-piece aluminium bellhousing and cast iron sandwich plate.
1. Undo the front engine mounts.
2. Support the transmission with a jack and remove the bellhousing bolts.
3. Remove the engine and bellhousing assembly from the vehicle using suitable engine
lifting equipment.
4. Remove the Landcruiser clutch.
5. Remove the flywheel.
6. Remove the sandwich plate from the engine.
7. Remove the oil pressure and water temperature senders from the Toyota engine.
D.
Transmission and Adaptor Kit Preparation
1. Remove the thrust bearing and carrier from the front of the gearbox.
Refer to diagram A for the next step.
2. Assemble the thrust-bearing carrier by first fitting the lock nut (4) onto the carrier (2)
then screw the carrier into the sleeve (5).
1. If your vehicle is fitted with the pressed metal thrust-bearing carrier and fork
remove the spring clip from the carrier.
2. The new carrier (2) has a groove machined in the back, sit the clip in the groove.
3. The bearing blocks (1) are then used to secure the spring clip. Fit the bearing blocks (1)
to the carrier (2) using the 4 x M4 counter sunk screws supplied in the kit. NOTE: Use
locktite on the screws.