beautypg.com

Proudly manufactured by – Advance Adapters 713025-EK User Manual

Page 11

background image

Page 11 of 11

13. Complete the exhaust system. NOTE: Heat shields must be fitted to the exhaust

system to prevent excessive heating of the engine mounting rubbers and clutch slave
cylinder. Failure to do so will cause premature engine mounting failure and possible
clutch failure in hot off road conditions.


14. Check all fluid levels.

15. Double check all mounting bolts are tight.

16. Start engine and check for-

Fuel leaks.
Oil leaks.
Water leaks.
Exhaust leaks.

Allow the engine to warm up and recheck above.

17. Refit the bonnet.

The components supplied in the kit are designed for specific type conversions.
Modifications to any components without the written consent from Marks 4WD Adaptors
will void any possible warranty or return privileges. Should you have any further
questions that are not covered in the instruction sheet, please contact our sales department
for assistance.

Remember an inexpensive phone call can save a costly mistake!

Proudly Manufactured by:

Marks 4WD Adaptors

1-3 Ventura Road, Dandenong South, Vic. 3175

Tel: (03) 9702 7366, Fax: (03) 9702 7566,

E-Mail:

[email protected]

Internet catalogue:

http://www.marks4wd.com

This manual is related to the following products: